Installation

The EZ Lock uses magnets to firmly hold to the cylinder.

  1. Insert the end of the cover that contains the magnets into the keyway first (this is the end with 4 fulll with knuckles)   EZ lock afbeelding 1

 

2.  Wrap the cover around the cylinder.

 

  1. Insert the second end of the cover into the keyway so that the two sets of knuckles engage each other

 

  1. Rotate the position of the cover on the cylinder as needed to increase cover life and to improve cutting quality. EZ lock afbeelding 2

 

Remove

Use the special Pry Bar tool to remove the anvil cover.

Place the Pry Bar tool below the keyway lock bar. To avoid damaging the cover do not attempt to pry under the cover in any other location.    EZ lock afbeelding 3